[Battle_axe]

this is for the ansmann X4 pro rolling chassis as i will be getting a new one for the winter



The car has only been ran for the summer regional series (5 times) and during the week for club racing about another 8 times



the car has a few mods to make it bullet proof or as close as possible



Rw racing spur gear and AE slipper pads (this means you must machine the slipper plates this was done by a machining company)

Kyosho zx5 diff bevel and crown gears.



Tamiya 511 front drive shafts.



small carbon front plate this makes the whole diff cover area allot stronger.



durango hinge pins all round to stop the problem of breaking hinge pins on the car



the rear wishbones have been swapped left-right and the shocks put the other side of the tower to stop the rear end squatting too low on acceleration and to shorten the car by about 3mm



all round this is a good car and being a team drivers car it has all the bits on it to make it reliable and fast



£150 ONO



will upload photos tonight