Quote:
Originally Posted by Sumilidon
I had the same issue, had to re-bind, and immediately after the thing went to full acceleration.
I fixed it by having the TX ready to bind, then switching the RX on - at this point I sent the bind command from the TX.
The ESC was plugged into the battery port.
Once bound, I switched the ESC off, unplugged the ESC from the battery port and put into the throttle, switched on and set the ESC.
Finally I attached the servo.
Since then, no problems - it just seems to be very VERY picky for the initial binding if not done in a specific way.
|
Thanks for that but I've also tried binding using a seperate battery pack from my aircraft radio with nothing else connected. Even that didn't work.
I did think it might be an issue with the original binding in as much as I might have had the throttle trim off centre when I did the very first bind out of the box, but I've tried binding to a different rx and still had the same problem and also tried then rebinding back to the original rx and the problem persists.