View Single Post
  #2  
Old 13-09-2011
Adam Skelding's Avatar
Adam Skelding Adam Skelding is offline
Senior Member
 
Join Date: Feb 2006
Location: Chesterfield
Posts: 784
Send a message via AIM to Adam Skelding Send a message via MSN to Adam Skelding Send a message via Yahoo to Adam Skelding Send a message via Skype™ to Adam Skelding
Default

The Manual shows how to install the brace in the most rigid condition.
To allow the flex system to work, simply remove the washer from the front screw.
This allows the flex brace to move for and aft in the slot according to how much pre-load you put on the rubber bush at the rear. You do this buy altering the amount of washers you put either on top of or below the bush before tightening the rear screw hard down. (Below is neater as you then don't see the washers).
__________________
5 Time Oople Invernational SC Champion.

Powered by OptiPower

Do, or do not, there is no try!
Reply With Quote