Quote:
Originally Posted by Rebelrc
There must be a spacing problem of some sorts on the rear stub axles
Check manual first then check you have correct crunch spacers etc
Sounds like wheel is not locating hard against the spacer/backplate gold thing, and there for when wheel is tightened it is adding shear stress to the pins
Hope this helps, let us know
Cheers
Scott  |
Possibly, there is a gap of approximately .5mm between the pin and the spacer/backing. A check on how deep the pin will go into the Rulux wheel, there is only a clearance of approx. .2mm. Which means the pins are driven hard against the bottom of the slot on the wheel.
I have added some shims now to reduce the gap. See how it goes. Worst case is to go back to TD wheels. Shame, I have quite a few new sets of Rulux wheels from my B44.1.
