Lads, im currently having a bit of a problem with one of my tekin setups.
Tekin rs pro, with redline 10.5. Its run in stock mode, tp1.
It runs fine, but after a couple of laps it starts cogging if the motor stops and is restarted. Looking at the sensor leds, once the motor is turning they flasj as normal.
Its not a temp issue as the onboard sensor is showing just one led. And nothing is hot.
Ive tried the sensor cable, and checked all the solder joins etc on the motor and the esc and dont see any obvious bad joints.
Any suggestions as to possible settings or any other ideas before i start trying different motors escs to try and get to the bottom of this?
|