Again apologies, my knowledge of connectors on goes as far as the white ones from a long time ago.
I'm assuming for using the lipos with the esc, I would need a bridging wire between the 2 packs, and 2 banana wires (1 from each pack) leading into a single deans connector. I am not sure if this is should be male or female however on the battery side of the connection.
On a seperat question as well, my old touring car is now working but I need to replace the 10 year old batteries. Thinking of a stick lipo instead of NiMh (35c, 5000mah) however concerned that may blow the esc and brushed motor.
Could I use that same wire in Mick B's post to connect it to the ESC?
|