[/tobys]

Is anybody else having this problem? I noticed when I ran as per kit (Plastic hubs, outside hole, 2mm spacer) that the wheels rubbed quite badly under full droop and it was audible when cornering at speed. I adjusted the setup (removed the spacer) to correct but wondered if there was a work around?

I have the same problem with the Alloy hubs rubbing when in the in the #1 position (very outer hole) as well.

Because the ball screws in the top, the angled rod ends that are available from various places (Jconcepts, Durango, etc) are not appropriate...

Thoughts/comments guys?