Quote:
Originally Posted by Dazzler
You are correct that the bump stop rubbers go on if not running the dust boots (as the boot has a similar chunk of rubber at the bottom. But you shouldn't be trying to fit them in the shock body / seal carrier as you apear to be suggesting, they just slide on the shaft before screwing the ball joint on.
|
Yes Dazzler i was trying to fit the tapered rubber into the body also..what a prat i am
Ahhh right,so i screw the anodised shock bottom on,then slide the tapered rubber onto the shaft where it sits up against the red anodised bottom?..thus not letting the piston protrude over the body?