[Mossy]

Sorry about the lateness in reply.

I run the front pin high on the rear pivot pin because I feel it gives a better balance to the car. Running both pin high I found made the car rotate too much through the corner, whereas running them both low meant that the car was too locked in at the rear end - co for me too much grip.

As for the weight, I have nothing up front. The Trishbits centre weight can be used with Rudebits lipo tray. I have raised Tony's tray by 2mm all round and that means that the weight I have off Trish can clamp around this - the one I have is in 2 parts and screws in from the bottom.

Ive also attached the setup I ran at Oswestry this weekend. The setup is the same as I ran in the wet to TQ round 3, only difference being I went to Ballistics. This should be a good base setup for Grass.