Quote:
Originally Posted by Lee Martin
201;
Try running the weight i advised above. also some things i have been going well with lately are:
Cutting rear arms 2mm and shortening wheelbase.
running plastic rear hubs in middle hole.
running inside hole on rear tower.
using backward ackerman position
using 25 degree caster blocks
79 spur with 24 tooth pinion
run yellow springs all round and 35 front 30 rear.
1.3 piston rear and 1.4 front.
i hope this helps.
8th - Unsure the best place to buy? maybe just direct from USA? unfortunately i cannot sell anything in europe.
Lee |
Hey Lee,
one more time thanks for your effort, it's precious!
I know your time is short and i promise this is my last post for you....
On 201 i need a couple more info:
1) Cutting rear arms 2mm and shortening wheelbase: I don't understand this copletely.... sorry but my english is not that good.....
2) Would you adivise to use the OPT chassis (high traction) on Dirt dry and low traction tracks?
Now on the 8th:
1) We will see some Set Up sheets on "your" TRF site?
2) If not, can you give some set up guide lines for Dirt dry and low traction conditon?
Thanks in advance.
Bye
WWD