Quote:
Originally Posted by reg
im not to sure the shims are for the lay saft,i would exspect them to be metal as the plasic would wear on the spinning part of eather the bearing or the shaft itself,i dont think they will last inside and wouldnt want them getting mashed up,i think they might be for the motor on the motor mount,
i keep asking on here because the more info that is available the more chance of the average joe(me)will get the most of this car just by looking on here,
|
Well, that was Kevin Lee answer :
The Shims are to shim the layshaft. Make sure you leave a little end float though so it doesn't bind.