No problem bud
1. Make sure all wire are to abc plug in sensor wire and connect to esc
2. Plug to battery
3. Turn on Transmitter
4.Press and hold setup button and switch on and hold till it starts to beep repeatably when beeping starts let go of the set up button
5. set the neutral range first simply by leaving throttle in neutral and press the setup button once there should be a single flash and beep.
6. Set full thottle range by holding your transmitter on full and press the set up button again there sould be two flashes and two beeps
7.set full brake/reverse by holding your transmitter in full reverse and press the setup button again there should be 3 flashes and 3 beeps
8. after you have done all of above switch off your esc then switch back on and leave for 3 seconds or so and then try pressing/pushing your transmitter to see if you get anything
BTW there is NO reverse with this esc so its forward and brake only.
|