RDG, from Exotek the wheel bolts are in but the idelrs and battery strap are on the next order from the USA, we only have pre-production ones at present.
DMS Partz shock tower is already online and the spur gears are the ones we already ahve for the X6 etc, they fit fine and offer 70 right throught to 80 teeth, using AE slipper pads
Hiro Seiko - is just the regular anodised stuff we have in terms of screws/bolts/nuts/washers/spacers etc....
On the brass flywheel, it fits "the car" fine (although slighlty better fit when I used X-Factory slipper plates as opposed to ther TLR ones), the only problem is you can then not fit the gear cover!! Some careful removal of material on the cover "should" allow you to run it without rubbing and any exposed areas (where the gear cover is cut) should be inside the bodyshell.... either that or try to fit an older gear cover from a XXX or XX that had room for the hydra drive etc......
__________________
ORCA - LC RACING - RUDDOG PRODUCTS - JCONCEPTS - ALPHA PLUS - TEKIN RACING - ULTRAPOWER
AVID R/C - VAMPIRE RACING - EXOTEK RACING - LUNSFORD RACING - X-FACTORY - TUNING HAUS - WTF
AME - RAGE R/C - REVOLUTION DESIGN RACING PRODUCTS - McKUNE DESIGN - TEAM AZARASHI
X-PARTZ - PHAT BODIES - RACERS EDGE - RM2 - DIRT RACING PRODUCTS - DMS INSERTZ
TKR GRAPHICS - BF MATERIALS - BATAN - DMS PARTZ - TEAM AJ Tel : (01923) 816636
|