[Adam Skelding]

Originally Posted by captainlip

They are the alloy ones, and I rebuild the buggy after every two race meets. The bearings are ok and moving freely, everything else is as new. As per your next post I cant help but say the supplied bearings could be better.

I don't see this thread slanderous to Durango, it's clearly just some frustration at wheel nuts falling off no direct comment. Secondly the thread was to start a good bit of banter but people take their toys far to seriously, it's just buggy racing

If it's the alloy ones. Then there lies your problem
Your kit must be an old one as these were discontinued in kits about a year ago.
They are now replaced with:
http://www.team-durango.com/part-inf...artNo=TD310032
&
http://www.team-durango.com/part-inf...artNo=TD714001 for the rear.

I'd advise you to put these in. Your alloy spacer will not be doing the job it should. It will have become crushed and not be supporting the bearings anymore.