Quote:
Originally Posted by 501x_NewUser
Hi, sorry if this is already mentioned else where. I also know this is a dumb question that I should know, but I don't and want to make sure before I mess it up 
I am looking at some 22 setups and I see the Anti Squat listed in the setup sheets for the Rear of the buggy.
Does this anti squat degree, mean the degree of the spacer under the HRC block + the degree of the piece that goes inside the HRC block? I notice that both have listed degrees on them. Or does this mean if I want 2.5 degrees anti squat I would have to use the 2.5 degree one in both cases so they match up? or does that add up to 5 degrees?
Anyway any help on this would be appreciated. Thanks ahead of time. |
Quote:
Originally Posted by Wacker 2
Just to add in that you only need to use the specific degree insert inside the front block if you are running mid motor configeration.
If you are running rear motor you will not need to worry about using the propper insert as you will just run the insert that you can screw into... and then just adjust it using the shims like you would have done with B4's of old!
Ta, Jon!
|
it only took 7 replies for the correct one lol