Quote:
Originally Posted by Panic
Hello guys,
Could someone tell me how can i solve the problem as my title says?
I m running a reedy kr 12x1 motor in my lazer zxr with mrt pro esc and nosram 3700 mah cells + 4200 ib cells . All the soldering iron which holds brushes, capacitors and wires on the motor after 2-3 minutes of running is melting. The strange part to me is that it is happening everytime i use the intellect cells . Motor was recently skimmed and fresh lay down brushes were installed, I dropped from 19t pinion to 16t but problem continued . For some reason though all previous mentioned is not happening when i m using my 3700 mah Nosram cells and i m able to empty a whole pack without a scratch. Is it possible that batteries might be the problem???If yes how can i fix it ?.?
Any advise will be highly apreciated,
Thanks
|
More capacity equals more run time, and this can cause the motor to overheat.
I assume you are running on grass, 16 to 100 gear ratio is too long for running on grass with a 12x1. I used 15-16 with 12x3 while running on dirt many years ago with that car and 1700 cells and it gets extremelly hot.