Quote:
Originally Posted by neo123
the motormount i have is the one that comes with it. not the black one. the hole top of the spur is gone(rinsed?) i was thinking maybe i have tightened the slipper too much, the manual says 3,5mm, but i have it on 2mm. and i cant feel any movement of the spur at all.
|
Ok I think we're getting somewhere. I think its stripping beacuse the mesh is just out (see below) or the motor mount screws are coming a little loose (use very small dob thread lock)
When you set your gear mesh you should get the pinion in the right spot and tighten the mount. Then slowly (a few teeth at a time) turn the spur over each time checking the mesh is still ok. You will probably find a tight spot and a loose spot. Be sure the mesh is set correctly to the tight spot and you should be ok.
If your slipper was too tight you'd have problems with the little gears in the gear boxes.