I'm having a couple of issues with the build guys. Followed the instructions to the letter as far as I know. Got the the back end in, but when the left side drive shaft is in situ and turnbuckle attached, the whole side will only lift slightly. I get full range of motion on the right side. It looks as though the drive shaft in diff end can only sit in so far and is hitting the nut that adjusts/keeps together the diff. Bit hard without pics I know, I'll try and get some up. This is driving me nuts. The plastic spacer that sits between the spring and nut is half way ish down the diff, but this looks right according to the manual.
Any ideas welcome.
Andy
|