Yep endbell timing on full for the SP v3 or it'll be dog slow.
You need a temperature gun to run brushless motors to their maximum, while not risking blowing them. Any time you change motors or ESCs, go to a new track or try a major ESC setting change, you should:
Do a 2 minute run and check the temp.
Do a 4 minute run and check the temp.
Do a 5 minute run and check the temp.
After 5 minutes you want the SP motor to be 70 degrees or below. If any of the intermediate checks are getting close to 70, you need to reduce the timing settings before doing longer runs.
|