Quote:
Originally Posted by Tempest501
The holes don't seem to be big enough to fit the screws (the ones the ball cups fit on). Whats the safest way to make them bigger?
|
There smaller then needed so people can drill them out to suit different ballstuds etc
Best way is to drill them out with a drill bit that's little smaller than the threads on the ballstud you plan to use. Then the ballstud can cut a thread as you screw it in. Then put a nut on the thread to make it secure.
You could also try a bodyshell reamer if you have one. But do this from one side then the other rather than straight through from one side.