[QUOTE=BORMAC;492743]Ok so here are some pics of where Im up to.
Im far from done and on the list I want to replace all the ball cups and studs, make up some lipo craddles, flip the rear inner suspension pivot pin bracket and look at the camber roll centres. I want to run a 12 turn single ORION 'V spec motor motor also.
The track in which I will be doing most of the driving is dirt. Sometimes it gets a groove up and other times its a little loose and dusty. The tyres fitted aren't going to be run either.
Any set up tips would be appreciated. Can anyone make some suggestions??
Nice, same towers i used in the very early 1990's. Set ups for clay i have zero idea as i race on grass, astro and carpet. But i suppose my base set up is a good start for anyone including someone as good as you. Then just go heavier on the oils or lighter all depending on how the car is.
Also there is a lipo tray design for your car but fibrelyte havent put on their site yet. You can dounble side tape the centre strut to the chassis so dont need to drill like me.
|