Quote:
Originally Posted by Juttie
I have a ezrun 5.5t 60a setup in my car and have just put a 11.1v 30c 80a lipo in the car, goes great but the esc is getting to hot and going into protection think I need a different speedy any suggestions?
|
If its this one you,ve got
http://www.hobbywing.com/english/Art...?ArticleID=419
the spec says you can use 3 cell lipo,s BUT your sreaming the nuts off it with a 5.5t motor.
The 5.5 t motor should only b used with 2 cell lipo on road.
1 Specification
1.1 Output: Continuous current 60A, burst current 380A.
1.2 Input: 4-9 cells NiMH/NiCd or 2-3 cells LiPo.
1.3 BEC Output: 6V/1.5A.
1.4 Resistance: 0.0007 Ohm.
1.5 Motor Supported: Sensorless Brushless Motor
1.6 Suitable Brushless Motor:
With 4-6 cells NiMH/NiCd or 2 cells Lipo: On-Road≥5.5T, Off-Road≥8.5T;
With 6-9 cells NiMH/NiCd or 3 cells Lipo: On-Road≥8.5T, Off-Road≥13T;