View Single Post
  #10  
Old 05-04-2011
TKG26 TKG26 is offline
Member
 
Join Date: Jun 2010
Location: Ottawa, Canada eh!
Posts: 140
Send a message via MSN to TKG26
Default

Quote:
Originally Posted by ian h View Post
Dremel the 2 pin ends into points. Simples.

Yep, even just taking the slight edge off the end of the pins does the trick... The reason there is an issue to begin with is from manufacturing process. The way those ends are cut leaves a slight edge or out of round tip... I believe they cut in a press.
Reply With Quote