Quote:
Originally Posted by markymark6183
Last week I went to my 1st club night and never got to race as my signal from my tx to my rx would not last more than 3 metres, that's all sorted so I went last night did one heat and now the motor will not go unless you physically move the wheels first it's a brand new fusion exceed 10.5t, we tried a new sensor wire on it, all the conections are spot on but it just doesn't want to know!!! Back to wheel spin models tomorrow to sort it out  I'm really starting to think its just not worth the hassle |
Please do not think it is a waste of time or effort as you will get it sorted and you will enjoy racing.
It does sound like a motor sensor issue and they should sort that out for you under warrenty.
The only advise I give anyone is to buy a good ESC. If it is expensive then it means it normally will last.
LRP/Nosram are top of the list, anything else will not last.
Batteries are batteries and motors are motors but ESc's are very critical.
If you need any advise on the Ansmann brand then please do not hesitate sending me a PM as I am a Works Sponsored driver for them and I will help out the best I can.
Thanks