Quote:
Originally Posted by Alfonzo
If the main area of your 'research' is the dual low / high speed damping, I wouldn't get too bogged down with the exact grade of piston rod steel etc, that can all be sorted later on. If you see what I mean.
|
You are right. the high low thing.
No, I'm not too bothered about making a mega shock rods out of stainless.
Whats important is being able to machine these things without busting my cheap taps.
I know very little about the various grades of stainless or the various grades of anything else for that matter.
All I know is, is that I can get a bunch of very shiny straight machinable rods for just a few quid. If I can harden these things to make them less scratch prone, then all the better.