Quote:
Originally Posted by West Ridge Racing
Glad you asked Till 
If you have noticed The Durango Dex410 and The Kyosho Lazer FS series have the motor mounted so the motor housing counter rotates towards the centre of the chassis instead to the right edge of the chassis as the original design does.
I asked Durango about this fact and that is why they did it. I am of The same opinion. They also said in the same reply that it is only effektive when during acceleration and not when up to speed. Then it did not matter as much. The rotor and centre shaft cancel each other out but The third factor is the housing itself. Initial acceleration and when the car is in The air it can help. It was possible to do this mod so I did it.
The wheel carry a lot of mass so they are more important balacing the car in the air.
So all in all, that is not The most important mod but I like the Idea that both Kyosho and Durango had so I copied.
The forward motor thing is also to make it more like Lazer or Tamiya 502 or Dex410. I find them to handle bumps better than B44.
I found all my insperation from those three cars. |
Thanks for your infos!! very intresting so i may have to mod my BMax, but I think it has enaugh felx =)