[Bagman]

Er, a bit of advice if possible.

The build is going smoothly then I get to page 32 C-7 (it's rear motored) but the mid build is the same at this point. Went to put the smaller bearing onto the layshaft before the slipper. No small bearing in the kit, but one extra larger bearing (LOSA6937 for the larger one). Thought I made a basic error so stripped down again to look for it but no it was built correctly. I've googled the part number that I need TLR2963 which comes up as the layshaft and spacer. Checked the manual and it is the same number for both the bearing and the layshaft. I could get the UK shop I bought it from to send me the part (providing they have it) but that would take over a week to get to me. All I need are the dimensions of the bearing and I can buy it locally.

Or am I doing something wrong, no bearing, it's something else, etc?