Quote:
Originally Posted by Tom3012
Mine went together like a dream, no flash to remove or anything like that...
Only difficult bit was the turnbuckles
|
Sorry, forgot to meantion turnbuckles. If you take a M3 x 20 screw and cut a slot up the length of it with the dremel (making a tap as such) and then use this to thread all of the ball cups. Use a bit of GT85 or WD40 on the turnbuckle as you thread it in for the first time.
If you do this, you will find that adjustment is really easy when on the car yet not sloppy or loose, and there it becomes alot more difficult to over tighted the rod into the ball cup causing yielding in the head and usually failure.
Takes the guts of a hour on its own.
Sorry for sounding a bit OTT, but if it's built right it'll perform better.