Quote:
Originally Posted by Gnarly Old Dog
Here is some build and setup info for the TLR22.
...
|
Gnarly Old Dog,
On the setup sheet you posted at the start of this thread the camber link positions are "1 + 1mm Spacer" for the front and "2 + 1mm Spacer" for the rear. Would I be right in reading this as using the inner inboard camber link position at the front, numbered 1 on the set up sheet and the outer inboard camber link position at the rear with the corresponding spacers under the ball stud? This seems fairly obvious but I was slightly thrown by the manual that shows the build using the outer positions for both front and rear inboard camber link ball studs but then states "#1 with 2mm spacers and 0mm spacers on caster block" for the front on the Kit setup sheet where "#1" would be the inner position?
Hope you can clarify this.
Cheers, Nick