Quote:
Originally Posted by jampat2004
i also had the issue with binding on the steering rack there was a very small burr on the fixed part of the rack which i removed with a small needle file and is now free.
i am also using a 1251 low profile i found by just slightly altering the underside of the bulkhead ie removeing a bit of the plastic there was enough clearance for the servo horn and ball cup without having to alter the ball cup at all.
|
That's great thanks, I'll get the rack out and have a look. What spacers are you running on servo as mine hits the servo just before reaching full right lock. Could possibly unwind the servo link one or two turns and see if I can make it work that way.
Ditto previous comment, thanks everyone for all your comments and advice. Looks like losi forum is back buzzing again, long may it continue
