Two minor issues still to resolve, both steering related..
I found there was some resistance between the two parts of the steering rack mouldings over part of the travel... Did anyone else find this? It's a bit difficult to know where/if to try and dremel it cause it's hard to tell where it is binding. I didn't notice any burrs.
The other one is the one Jimmy and others mentioned, with the ballcup fouling on the front of the servo near full right lock. Running Savox LP servo with 2.5mm spacers. I have done a little dremelling to the underside of the top brace to deal with the other ball joint but now the only coice seems to be find a small ballcup or dremel the existing ballcup or the servo.
There are lots of things to like and marvel at on this car but the steering could do with a little more flexibility in the design, the tolerances are just too tight/non existent.
|