Quote:
Originally Posted by jimmy
Ok I've fixed it now, I shaved some off the bulkhead and probably too much off the ballcup (watch it break as soon as I drive it) oh well - it was pretty smooth until that 
Servo is flat to the bottom and I've got the manual suggested shims - but the link is too high anyway, wouldn't matter how far forward/back the servo was, it will always hit the bulkhead. (well, until I've shaved lots off) |
I think the problem lays with the ball cup. Certainly the supplied one can be problematic with hitting the servo case with a Spektrum S6070.
I used Losi JRXS ball cup LOSA6017 which is a lot lower profile and it just clears the underside of the bulkhead without having to dremel anything.
Famous last words Jimmy but don't worry too much about the strength of the front bulkhead - I did dremel lots off on the prototype and I hit some things pretty hard without any problems
As for the Front hinge pins - sorry but I'm not sure of the actual material - just that they are Ti Nitrate coated I believe.