I raced this new design today and is far better then the previous one.
Not only looks batter (witch is always importante), but holds on better.
The other board as I explained before, was made from layers, and two boards glued together. After a few runs it became cracky and flexible, clearly about to break.
This one with only 3mm has some flexibilit, but is consistent.
During the race today, a had a few crash's ( far more than I wished), and some were very uggly.
It slided top down a couple of times and rolled lateraly a few times at the exit of the table jump.
Didn't break and I have not detected any crack.
I think its aproved.
Petty I could find no one yet in the n
eighborhood that can mill this shape from the board, but I'll keep looking.
Mean wile they will come out as handycraft stuff.