Are you sure you programmed your ESC properly?
Here is the setup routine for your ESC;
1- Press your ESC setup button while the Led's are flashing. When the button is pressed, the neutral setting will be stored.
2- the Green Led will now light, showing that the ESC is ready to accept the full forward speed setting
3- now press the trigger control to where you want full forward to be
4- now move the trigger back to the neutral position, and the ESC will store the full forward setting
5- the Red Led will now light showing that it's ready to accept your brake/full reverse setting.
6- move the trigger to full reverse/brake
7- move the trigger back to neutral, and the ESC is all set up.
You may of done this process pressing the trigger in reverse for the fwd setting, and vice versa.
Your ESC appears to working properly otherwise.
|