We run "Mardave Unlimited" which means we dont use 1c batteries but 2c. Mine is placed over the length of the chassis.
setup:
- Jap 40, front strut brace, 2mm caster, stock spring (one coil removed)
- Yokomo*, shim under pivot, 2 0-rings under rear of the pod, stiff spring
* Keep chunking the Ufra because of the bouncing problems.
Car goes good enough, but sometimes it steppes out in the back ( starts bounce in corner )
So what I see in the suggestions:
- try tubing in the front
- try removing shim under rear pivot
Maybe also try weight in the back ? or other suggestions