Quote:
Originally Posted by stevo16v
battery tray on itsway buddy
|
Quote:
Originally Posted by stevo16v
run silicon tube the full hieght of the king pin but about 1mm short so it doesnt bind the steering , i leave the springs on aswell to take up the slack
i put washers under the front wishbones ,a general rule is the more
|
Springs & Tubing
, why?
Quote:
Originally Posted by stevo16v
the last tip and one of the most important is if u use a fast servo turn the speed down ,if it turns the steering to fast u will simply wash the front out ,the car should drive round the corner ,if it locks over to fast the car wont steer properly till the cornering speed is reduced,ive got a corelesss futaba turned down to 60%
|
Might have experienced this last night after fitting a RC Dynamics booster to power the servo. I'll try next time without. Don't think my DX3s will slow the servo down thought, I may be wrong. Servo's a Savox 1251MG