Quote:
Originally Posted by Chequered Flag Racing
Is the above for a brushless Dave or Dave's in general?
How much tubing do you use?
Enough so the chassis has no front droop or are we looking for a little droop?
4mm caster
is that 4 mm of spacing or 4mm of incline as measured from the top of the king pin?
dont forget the nylon battery trays
you have funds 
|
battery tray on itsway buddy
run silicon tube the full hieght of the king pin but about 1mm short so it doesnt bind the steering , i leave the springs on aswell to take up the slack
i put washers under the front wishbones ,a general rule is the more washers the more hi speed bite u will remove thus allowing u to run gripper tyres for the low speed corners without spinning out ,think of caster on a shopping trolley,
the last tip and one of the most important is if u use a fast servo turn the speed down ,if it turns the steering to fast u will simply wash the front out ,the car should drive round the corner ,if it locks over to fast the car wont steer properly till the cornering speed is reduced,ive got a corelesss futaba turned down to 60%