[kaylon]

Hi Rednoise.

The current mounts I've done share the same chassis and shock mounting locations but the frame is slightly different in design. Can easy change them.

As far as file format goes. I can read .dpp, .ai, .dwg, .dxf, .eps and .pdf

The milling software actually reads .pdf to work from. Currently we are working in 2.5d so depth of cut needs to be specified on any work. Milling from 3d files is possible but requires a lot of set up. However we can work from Sketch-up files .skp also .obj and .3ds are possible but tricky.

Hope that info helps.

J