Quote:
Originally Posted by OneKiwi
Another Q where can I get a little wing to go on the front of the buggy??
Or whats a good way to weight the front down a little more?
|
a few methods..
1 ) fit a low profile servo such as a Savox & make a brick out of lead weights & stick it behind the servo with a couple of weiights on the top of the servo for good measure (i've seen this done on a couple of rats / xpro's)
2) run cells & not LiPo or run weights along the battery bar, i've also seen people using brass battery straps
3) alter the rake of the suspension so the front is angled slightly downward more - this used to work well on old 2WD Tamiya's such as Hornets, Boomerang etc so may work on other cars but may require some set-up on more advanced cars of today as i've not tried this since i binned my Hornet some years back.
4) see if you can get (although you may have to make) a metal front brace / suspension holder, the one for between the wishbones or the skid plate.
5) stick blu-tac or plastercine into every nook & cranny such as under the chassis plate, the further forward & lower to the ground the better.