Quote:
Originally Posted by ianhaye
can you not swap the rx and esc around so areal doesnt have to run over the esc? also try anothe servo, a dodgy servo can also cause these probs, mine even made my esc shut down sometimes.
|
Quote:
Originally Posted by i4n
Move the receiver/aerial away from the ESC (general rule of thumb, keep the aerial as far away from the 'power' electronics as possible).
The power capacitor smooths out any possible dips in voltage to keep the receiver powered up that you may get under hard acceleration. I had problems with what I thought was interference and it was this, always run one now and no problems. You can buy them from Spektrum or make them up yourself (there's instructions on oOple somewhere if you have a search).
|
As these guys say also if your running a pt to close i have had this problem with Savox servos but no other brands