Quote:
Originally Posted by QuackingPlums
I'm using Createx/AutoAir, which I think is the same as Faskolour?
I found that if I just spray the cleaner/water through it then paint is still visible at the bottom near the needle (it's a gravity direct feed) where I can't get at it with tissue, which is why I ended up dismantling it all and soaking it in cleaner.
I'll certainly leave the needle backed out when not in use from now on, as I noticed when I first got it going again that the needle seemed "sticky" - as if it wasn't going all the way back in when I released the button.
|
sounds like a little blockage in the nozzle give the needle a wipe with a scouring pad gently wipe all acsess paint from it then push it back in th nozzle wipe the tip and try again