Neu 1509/2y/s 1820kv motor - £30 requires sending off to neu to be repaired as the rotor just spins and there is no drive. Would make a great motor for any 1/8th buggy or smaller car.

HPI temperature gun - £15

Propeak sigma eq charger ac/dc and comes with the balance boards for all the different types of lipo connectors, it's in excellent condition hardly been used (boxed and with instructions)-
http://www.tjdmodels.com/product.jsf?productId=2682
£50

ultrapower 15A power supply (boxed and with instructions) - £15
Now onto the motor
first up is a 9xl (1900kv) brushless motor with rc-monster clamping heatsink (will sell seprately if wanted) - £25
Spektrum Dx3 system with 1 receiver (has had a repair done to the aerial which has made it short) boxed in good condition - £70 posted
Mod 1 pinions ( 12, 13X2, 15, 16, 18) £5 each
2 X Zippy-R 4500mah 21/30C 14.8v/4s lipos perfect for 1/8th scale setups. in good condition approximately 30 runs in total and matched to each other so you can use them in parallel for a whopping 9000mah single battery. an extra layer of clear heatshrink has been added for extra protection and one of the batteries has a small tear in the white heatshrink below this but this doesn't effect how it runs - £40 for the pair

2 X FTX 5000mah 20C 7.4V lipos again perfectly matched to each other so they can be used in series for 14.8V of voltage - £40 for the pair
(the heatshrink on the wire has cut near the exit of the wires from the hardcase but this has been taped and i can heatshrink before i send it out if you want. there are scratches on them but none are serious)
Both + postage
Dimensions of the batteries:
Zippy R's - 200X45X20 each (LXWXH)
FTX 5k's - 135X45X22 each