Thread: losi8t with tekin rx8 2650kv rtr
View Single Post
  #1  
Old 24-08-2010
losi madness losi madness is offline
Banned
  
Join Date: Jun 2010
Posts: 274
Default losi8t with tekin rx8 2650kv rtr
hi selling my new losi 8t its been used 1 times from buying my new tekin sytem for it . its like new the truggy and shell comes with loads of spares and the rx8 sytem comes with hotwires and 2 packs of 4s lipos 3000mha 35c . the sytem as been set up and that it . only got this pic till later £500 posted . these pics are old pics before i put the rx8 sytem in it

LOSI 8IGHT - T BRUSHLESS CONVERSION

Bought this second hand about 9 months ago as a project. It looked to be in good condition but on delivery it was sadly a little tired. Since then I've sent a fortune refurbshing it and could have bought a new one for what it cost me. To name a few things:
  • New Hinge Pins
  • New Hing Pin Braces
  • New Hinge Pin Brace Covers
  • New Suspension Arms Front and Rear
  • Fully rebuilt Dampers
  • New Wing
  • New Protoform Body (This wasn't professionally sprayed so on close inspection there are a few flaws but from a distance or bashing it looks fine
  • New Bearings all round
  • New Diff Oil (7-10-5 Front-Centre-Rear)
  • New Hubs / Carriers front and rear.
  • New Servo Saver / Steering Linkage
  • 1 New Diff Cup (Think the front one)
Also Included:
  • Losi Brushless Conversion kit fitted - Original Plastic ESC mount cut off so I could bolt the Beast ESC to the Chassis.
  • Carbon Suspension Mounts (Fitted)
  • Several Sets of Suspension Springs
  • Original Alloy Suspension Mounts
  • Damper Rebuild Kit
  • Comes fitted with Towerpro MG995 Steering Servo.
  • Comes with Acoms Reciever (NO XTAL OR TRANSMITTER)
  • Masses of Spares - Mainly the bits I've replaced but for a quick fix if you break something there should be enough to get you running again.
  • When I bought it I was told there are enough bits to convert it back to nitro if you want. I cant verify this but there are a load of nitro parts (Fuel tank / disc brakes / throttle linkage / engine mounts / Spur gear etc).
  • Original (tired) Body
  • Instructions + Box
  • Original Losi Wrench (not shown in the piccy's
.







there loads and loads of spares with it 2packs of 7.4v 25c x2 and 2 packs of 4s packs 3000mha 35c