Quote:
Originally Posted by DCM
Whats your exact setup?
Spektrum is very sensitive to voltage.
|
My exact setup is:
HPI Vorza Flux
Tekin RX8 Speedy
Spektrum SR3300T receiver
Spektrum DX2S controller
2200kv brushless motor (the stock one that comes with the vorza)
1 servo: HPI SF-5 high torque metal gear servo
Battery: Vemon Li-POWER series 18.5v 3800mah 5s1p 35C hardcase battery pack with Deans connector
I have had a battery tester plugged in at the time that the receiver cut out and the battery was fine. Each cell had plenty of volts (eg 3.8 volts), and were within 0.05 volts of each other.
It would be interesting to see what voltage was coming down the line between the esc and receiver, but that's a little harder to do.
Any other ideas?
Thanks for the thoughts so far! no response from Spektrum as of yet....
- Andy