Three quick picks of the Castle MMP in the TRF511
You might notice there's a small gap between the end of the centre shaft and the edge of the heatsink. It's about 2mm.
There's so little flex, there's no mark on the heatsink after half a dozen meetings or more.
The motor wires are run down alongside the speedo, along the bottom deck, then come up to cross over above the front belt, then across to the motor.
I've had the speedo out twice now, to clean, and refresh the install - I don't trust to failure - prefer to re-install periodically, just to be safe.
Next time I'm doing the re-install, I'll produce some more pics.
|