Quote:
Originally Posted by nikos2002
I would be careful with the front diff according to your set up. We found in testing if you followed the directions and put a shim on each side of the diff, there was a much better chance of no issues. Yes you can put two on one side and one on the other for a tighter mesh, but the kits only come with 4 shims. Our part number is TR4039 for additional shims (not sure if everyone is using the same part numbers). The drive train is so free out of the box. I would recommend the extra shims, especially if you are going to run a hotter motor.
|
Hi Nikos It's sitting on my table so I went and double checked the instructions, part TR4039 is the diff rings. Nicefrog was referring to part 86000 to take play out of the rear gear mesh.
