Lets take some time to sit back and see where we are up to now
Steering installed
Front upper brace and front shock tower mount installed
It was very late at night when we started the build so that's where we called it quits, we will finish the car and the thread tomorrow
Ok back now
Front shock tower installed
Rear tower installed
Overview of the car so far
Looking down the front of the car
Spur cover installed
One again the entire car
Side profile
Showing the crush tube spacer thing that goes between the bearings and the 10 degree hubs (the kit comes with both 10 and 13 degree hubs), I installed the first one I grabbed randomly for starters, which were the 10s
Front arm and hub installed
Underneath the front end
Close up of the front hex adapter and roll pin that presses into the axel
Front end wide shot
Close up of the roll pin before being knocked into the axle
Loosening a couple of screws to easily get the rear arms on