Well my car was set up like this, and flew through there, it is a lot about the line you take though....
Front -
Green spring
Red GHEA piston
30wt Losi oil
AC tower middle hole
Middle hole on wishbone
Front caster blocks moved forward 1 wheelbase shim
lead under servo weight, 15g in bulkhead
VLA short
Rear -
Pink spring
Red GHEA piston
27 1/2 wt Losi oil
Out 1 hole on tower
Extra inner hole drilled on BK2 wishbones
Old XXX rear pivot block (well actually the ali one off the CR Truck)
~1/2 deg antisquat
No lead under Lipos
Rudebits T-piece
CR degree hubs
Short wheelbase
VLA short
For a start on the kit CR back end I'd say your shocks are too hard and out to far on the wishbones. I only ever used the inner hole on the wishbones or an extra inner hole I drilled.
Is that any help?
G
|