Not managed to get the b44 hexes on properly, you need to drill them out and open up the slot for the pin to go in as the tamiya uses a thicker pin! I tried but they ended up binding as well after i drilled them out!
The plastic spacer was by far the easiest solution. My rulux binded on the hub with the stock hex without using the spacer!
On a bit of a different note, The cat sx fronts fit alright just using the plain pin! no binding unless you really torque the wheel up! Would be nice to use the disk that schuy use on the cat behind the pin but the hole in the center of that is to small!
|