[madonrc]

Looking for a brushless system for any vehicle, buggy , truggy, SC around the 1/10th scale well here it is

i have the perfect thing for you. Its a 100% waterproof brushless ESC and motor. This has never been raced. I purchased it new and installed it in my spare touring car which i use a s a wet car, but never had the oppertunity to use it. It cost £150 new, i would sell it for £85 posted. Heres the spec on it

G2 ESC and P2 brushless motor combo set. The new standard in brushless performance and power!

The G2s complete re-design will show that brushless technology has just reached a new high!

The G2 Pro brushless speed control and motor set has been designed to use in 1/10 scale competition on and off road racing. It has been optimised to give the best possible performance and top speeds when used with high quality P2 brushless motors.

The new features and high performance components used to build the G2 is what makes the G2 Pro the most competitve speed control in its class today. When used with the matched P2 motor complete with the set you can expect to see unbelievable control and power. This completely new speed control set sets new levels is brushless speed-control technology.

Combo Set includes:
G2 Pro ESC
P2 10.5T motor
Pit-Card ESC programmer
G2 Pro ESC features:
Perfect sensorless drive
New G2H - high performance heat dissipation power boards
New G2 software increases power and top speeds
100% Waterproof
Safety features including thermal cut off
NiMH/NiCAD/LiPo Support
Built in data logger (8 minutes maximum)*
New adjustable features via included Mtroniks pit card - Very easy to use
New high power brakes, fully adjustable
New high power drag brakes, fully adjustable
Reverse lock out
Input voltage - 4.8 to11.1V
Motor limit - On Road - 3.0T
Motor limit - Off Road - 4.5T
Small size - 42.0 x 27.0 x 23.0mm
Weight - 66g (excluding wires)
*Data logger requires a Windows PC and the optional Mtroniks pit software available seperately

P2 Motor features:
Military spec neodymium sintered magnets
Standard 540 can size and weight
User friendly solder tabs for easy and neat connection to the speed control
Re-buildable design to help keep the motor clean and running at highest possible performance
High performance, low friction ball bearings
Hardened 3.17mm motor shaft to match all existing standard pinions
Anodised solid can for better heat removal
Full range of winds available